[month] [year]

Sumana Bhattacharjee – MS in ECE

Sumana Bhattacharjee received her MS in Electronics and Communication Engineering (ECE). Her research work was supervised by Dr. Aftab Hussain . Here’s a summary of Sumana Bhattacharjee’s MS thesis, Design and Fabrication of a Microfluidic System with Nozzle/Diffuser Micropump and Viscosity:

In this thesis, we have discussed two microfluidic sensors, microfluidic micropump, and viscosity sensors, for biomedical and industrial applications. We have done simulations, mathematical analysis, and fabrication of the mentioned devices. Micropumps are one of the most important parts of a microfluidic system. In particular, for biomedical applications such as Lab-on-Chip systems, micropumps are used to transport and manipulate test fluids in a controlled manner. In this work, a low-cost, structurally simple, piezoelectrically actuated micropump was simulated and fabricated using poly-dimethylsiloxane (PDMS). The channels in PDMS were fabricated using patterned SU-8 structures. The pump flow rate was measured to be 9.49 µL/min, 14.06 µL/min, 20.87 µL/min for applied voltages of 12 V, 14 V, 16 V respectively. Further, we report finite element analysis (FEA) simulation to confirm the operation of the micropump and compare favorably the experimentally obtained flowrate with the one predicted by simulation. By taking these flow rates as a reference, the chamber pressure was found to be 1.1 to 1.5 kPa from FEA simulations. Viscosity measurement has wide-ranging applications from the oil industry to the pharmaceutical industry. However, measuring viscosity in real-time is not a facile process. This work provides an elaborate mathematical model and study of measurement of viscosity in realtime using pressure sensors. For a given flowrate, a change in liquid viscosity gives rise to a change in pressure difference across a particular section of the pipe. Hence, by recording the pressure change, viscosity can be calculated dynamically. Mathematical modeling as well as finite element analysis (FEA) modeling has been presented. A set of pressure sensors were placed at a fixed distance from each other to get the real-time pressure change. Knowing the flow rate in the channel, the viscosity has been calculated from the pressure difference. For the finite element analysis, the pressure sensors were placed 60 mm away from each other. The radius of the pipe was 19 mm. A different ratio of the mixture of water and glycerol was used to provide variable viscosity, which led to the variation in pressure-difference values.